Britax ROUNDABOUT 55 Guia do Utilizador

Roundabout® 55User GuideIMPORTANT: Thoroughly read and follow all instructions before installing this child seat. Store this user guide in the pocket

16 17Harness Height AdjustmentNOTE: In rear-facing mode, always position the harness straps at or below your child’s shoulders. See page 6.In forward-

18 19Adjusting Buckle Position1 Unbuckle the harness. Remove the belly pad and push the buckle through the cover. 2 Turn the buckle webbing and slid

20 21Fastening the BuckleInsert one tongue at a time into the buckle. NOTE: Proper connection is confirmed with an audible click after inserting each

22 23Recline PositionsThis child seat has 3 positions. To adjust, pull the recline handle then rotate the child seat shell into the desired position.

24 25Using Lower Anchors and Tethers for Children (LATCH)Lower Anchors and Tethers for Children or LATCH, is a system available on this child seat tha

26 27WARNING: • Attach the Versa-Tether only to tether anchors identified by your vehicle manufacturer as tether anchorage points. Only use the desig

28 29The Versa-Tether can indicate when the child seat has been in a moderate or severe crash (see page 4) and replacement of the child seat is necess

30 31Before You Begin:• Check that your vehicle has lower anchors.* Refer to your vehicle owner’s manual or contact the vehicle manufacturer for the

32 331 Place the child seat on the vehicle seat. 2 Firmly press the lower connectors onto the adjacent lower anchors.• A click confirms attachment.•

34 35Lap-Shoulder Belt InstallationInstall with lap-shoulder belt as shown above.Before You Begin:• Check that your vehicle belt is compatible for us

©2010 Britax Child Safety, Inc. All rights reserved. Printed in USA P417300_R1:07.10This product and its components are subject to change without not

36 37Checklist 9 Check that the vehicle belt is securely fastened. 9 Check that the child seat cannot be moved front to back or side to side more than

38 39Lap Belt InstallationInstall with lap belt as shown above.Before You Begin:• Check that your vehicle belt is compatible for use with child seats

40 411 Loosen the harness. a Lift harness adjuster leverb Pull both harness straps forward2 Remove the body pillow, unbuckle the harness, and remo

42 43Before You Begin:• Check that your vehicle has lower anchors.* Refer to your vehicle owner’s manual or contact the vehicle manufacturer for the

44 451 Place the child seat on the vehicle seat.2 Firmly press the lower connectors onto the adjacent lower anchors. • A click confirms attachment.•

46 47Before You Begin:• Check that your vehicle belt is compatible for use with child seats. See pages 8 – 13 for more information.* If your vehicle

48 491 Loosen the harness. a Lift harness adjuster leverb Pull both harness straps forward2 Remove the body pillow and unbuckle the harness. 3 Li

50 51Lap Belt InstallationInstall with lap belt as shown above.Before You Begin:• Check that your vehicle belt is compatible for use with child seats

52 531 Loosen the harness. a Lift harness adjuster leverb Pull both harness straps forward2 Remove the body pillow and unbuckle the harness. 3 Li

54 55This child seat is certified for aircraft use. Most airlines in the U.S. and Canada will allow the use of a child seat as long as it is labeled a

2 3Section TitleSection Title• Use only in a rear-facing position when using it with an infant weighing less than 20 lbs (9.1 kg) OR is less than 1 y

56 571 Loosen the harness. a Lift harness adjuster leverb Pull both harness straps forward3 Open the chest clip.a Press tabsb Pull apart3 Release

58 59Cover RemovalWARNING! Never remove the buckle tongues from the harness. They cannot be reattached after removal. If reassembled incorrectly, the

60 6112 Remove the cover from the child seat shell.Care and MaintenanceCare and MaintenanceCleaning the Cover• HAND WASH the cover using cold water

62 635 Nest the harness straps by inserting the right strap loop into the left strap loop.Care and MaintenanceCare and Maintenance6 Before reattachi

64 65Tips and TroubleshootingCare and MaintenanceRe-thread the Buckle1 Guide the buckle retainer down through the slot in the child seat shell.2 Sli

66 67This child seat was manufactured by Britax Child Safety, Inc. Britax® warrants this product to the original retail purchaser as follows:LIMITED O

Britax Child Safety, Inc.13501 South Ridge DriveCharlotte, NC 28273USAA Britax Childcare Group Limited companyTel. : 1-888-427-4829www.Britax.com

4 5Important Notes• Verify that the child seat is securely installed and the harness is properly adjusted around the child each time the child seat i

6 7WARNING! REAR-FACING use of this child seat is ONLY for children who meet ALL of the requirements below. If the child cannot be secured within thes

8 9Compatible Vehicle Seat BeltsNOTE: The information in this section only applies to installation with vehicle seat belts. Vehicle seats and seat bel

10 114. ELR (Emergency Locking Retractor) with a Sliding Latch Platea Has a latch plate that freely slides along the vehicle seat belt webbing.b Has

12 13WARNING! DO NOT place child seat rear-facing in the front seat of a vehicle with a passenger air bag unless deactivated. DEATH or SER

14 151 Cover2 Harness Slots3 Comfort Pads4 Infant Body Pillow5 Harness Holder6 Lower Connector Bar7 Lower Connector Strap (LATCH component)8 L